fabio83
23-05-2014, 12:58
ciao a tutti , sono nuovo del forum e un po inesperto di logic. ho una scheda audio m-audio fast track ultra 8r e un effetto lexicon mx200. ho letto che si più usare anche come hardware plug in esterno , ma non capisco come fare . nelle istruzioni dice di fare uno stereo bus dal main mix master , ma non so come si fa . metto le istruzioni in inglese , cè qualcuno che mi sa spiegare ? grazie .
Create a Stereo Bus (or two audio
busses) that are different from your Main
Mix (Master) Bus.
2. Route these busses to the outputs on
your audio I/O hardware that you have
connected to the MX200 (Either the
S/PDIF output, or two analog outputs).
3. In your VST or Audio Units Send Effects
Routing options, send the MX200’s
effect sends to the Stereo Busses (or
Bus Pair) you created in Step 1.
4. Create two audio tracks whose inputs
correspond to those you connected to
the MX200 (Either the S/PDIF input, or
two analog inputs).
5. Route these tracks to the Main Mix
(Master) Bus.
Create a Stereo Bus (or two audio
busses) that are different from your Main
Mix (Master) Bus.
2. Route these busses to the outputs on
your audio I/O hardware that you have
connected to the MX200 (Either the
S/PDIF output, or two analog outputs).
3. In your VST or Audio Units Send Effects
Routing options, send the MX200’s
effect sends to the Stereo Busses (or
Bus Pair) you created in Step 1.
4. Create two audio tracks whose inputs
correspond to those you connected to
the MX200 (Either the S/PDIF input, or
two analog inputs).
5. Route these tracks to the Main Mix
(Master) Bus.